Asante Asant'eFAST 10 Guía de instalación descargar pdf (Pagina 16)

Page 3-2

Installing Network Drivers

Installing Network Speciﬁc Drivers

Novell NetWare 3.x Client

This section shows you how to install Novell NetWare version 3.x ODI client

software.

Create a directory named NETWARE on your C drive.

To do this, type the following command at the DOS command

line prompt:

MD C:\NETWARE

Insert either the NetWare WSGEN disk that came with NetWare

3.x or your master workstation disk into drive A.

Copy the following three ﬁles to the NETWARE directory on your

C drive.

❏

LSL.COM

❏ IPXODI.COM

❏ NETX.COM

➪ Important: The AsantéNIC-PCI adapter requires

LSL.COM version 2.10 or later. Please check the version

number of your LSL.COM ﬁle.

Remove the NetWare WSGEN or master workstation disk from

the ﬂoppy drive.

Insert the Asanté Driver Disk into ﬂoppy drive A.

Copy the NET.CFG and the ODI driver ﬁles to the NETWARE

directory on your C drive. To do this, type:

COPY A:\NETWARE\NW3.X\CLIENT\NET.CFG C:\NETWARE

COPY A:\NETWARE\NW3.X\CLIENT\ASANTPCI.COM C:\NETWARE

Check your CONFIG.SYS ﬁle to make sure that this line

appears:

DEVICE=C:\DOS\SETVER.EXE

If you don’t see it there, type it in, then save the ﬁle.

∆ Note: The SETVER.EXE ﬁle must be in the C:\DOS

directory.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Sin comentarios

Asante Asant'eFAST 10 Guía de instalación Pagina 16