Asante 10Base2 Manual de usuario descargar pdf (Pagina 15)

APPENDIX

- PAGE 15 -

4. TROUBLESHOOTING TIPS

In the unlikely event your network is not operating properly, follow the

troubleshooting tips below.

LEDs

There are two diagnostic LEDs on the media coupler:

LINK (green) – on when a network connection is made to a hub. The link indicator

is not used when connecting to a 10Base-2 network.

ACT (green) – shows activity on the network when traffic is being sent or

received.

CABLES

10Base-T

The maximum distance from any node (computer, printer, hub, switch, etc.) is

328 feet or 100 meters. Be sure your cable is not coiled, twisted or damaged.

When connecting the switch to a computer, be sure your Category 5 UTP cable is

wired for straight through: pins 1, 2, 3 and 6 should be matched pin-for-pin on

both ends. Note that pins 3 and 6 must use the same twisted pair; these are

typically orange/white orange or green/white green.

10Base-2

A 10Base-2 network must have a terminating resistor at each end of the cable.

If you are unable to connect to the network, check the termination first. Be sure

your cable is not coiled, twisted, or crimped, and that none of the shielding is

visible where the cable is inserted in the T connectors.

Check your computer’s software. Check your operating system manual for

instructions on configuring your network for file and print sharing.

1 2 ... 10 11 12 13 14 15 16 17

Sin comentarios

Asante 10Base2 Manual de usuario Pagina 15